River sand vibrating filter sieve with 2 outlets

Original
price: Negotiable
minimum:
Total supply:
Delivery term: The date of payment from buyers deliver within days
seat: Beijing
Validity to: Long-term effective
Last update: 2017-12-14 19:17
Browse the number: 85
inquiry
Company Profile
 
 
Product details
Working principle
DZSF series linear vibrating screen is a vibration motor drive,When two vibrating motors do synchronous reverse rotation,vibration force produced by the eccentric block in parallel to the direction of the motor axis offset each other,in the fold is perpendicular to the direction of the motor shaft for a resultant force,so the trajectories of sieve machine for a straight line. Two motor shaft relative screen surface a dip in the vertical direction,the vibration force and material from the force of gravity,the material being thrown up on the screen,jumping forward or a straight line so as to achieve the purpose of the screening and grading the supplies. Suitable for particle size in 0.074 5 mm,water content is less than 7%,non-viscous all kinds of dry powder or granular materials of screening The largest feed particle size is not more than 10 mm.
After installing the new screening machine, the following requirements shall be checked:
1, check the vibration motor winding insulation resistance to earth, before using if <20MΩ must be dried.
2, sieve and base unit, the lower spring retainer, spring should be completely vertical embedded spring retainer to ensure balanced sieve, vibrating sieve machine not part with any other object outside the machine rigid connection or contact.
3, close the power switch, make sure the vibration motor synchronous reverse rotation, air operation carried out for 10-20 minutes, the device at runtime if abnormal sound, should be checked promptly shut down process. After the device is working properly, can be a small amount of material to be sieved through the inlet into the screening machine set to confirm the material to the discharge port direction of travel, and then gradually increased to the desired feed rate can bear.
4, when the screening material, the inlet should be put into the material evenly to ensure uniform distribution of the material the screen surface. When the material whereabouts, not a big impact, so as not to damage the screen, under exceptional circumstances (such as material differences between the large particle size, material than the major, etc.) should be added in the feed opening as a buffer layer of coarse mesh.
5, the user can according to different layers, the material increase or decrease in proportion to the screening machine screen machine vibration force (by adjusting the angle between the eccentric weight at both ends of the vibration motor to increase or decrease the excitation force), the screening machine to achieve the best the screening effect.
6, the device generates an instant resonance region during downtime, in which case the amplitude and noise will be significantly increased, is a normal phenomenon, equipment downtime before the open, the screen surface may not have retained the material, screen often need to check whether the tension, damage , to be immediately replaced if damaged.
Total0bar [View All]  Related Comments
 
more»Other products

[ Products search ] [ favorites ] [ Tell friends ] [ Print ] [ Close ]